Spirit Rei | Fender Flares +50mm for Toyota Hiace 100 Series
Spirit Rei | Fender Flares +50mm for Toyota Hiace 100 Series
The vehicle we developed is a 4WD, a must-have in snowy regions.
Lowering a 4WD vehicle is difficult due to the front differential and driveshaft, and since it's used for both work and leisure, we felt that a 2-inch lowering was the limit of what we could achieve through suspension.
To fill the large gap between the fender and tire, we began sculpting along the panel lines of the original fenders. While lowering the front by 55mm and the rear by 50mm, we achieved a fender arch that was as natural as possible, resulting in a simple-looking but carefully crafted fender.
The overfenders project approximately 15mm, allowing the wheel rim and tire to peek out for a racy look.
Material: FRP (Painting is required after purchase)
*We do not accept painting requests.
Finish: Black gel coat
. Installation is with double-sided tape.
Projection: Approximately 15mm
Arch Down: Front: 55mm, Rear: 50mm
PLEASE NOTE:
This is a Japan parts Service, some items are made to order (typically 4-8 weeks to make)
If you select air mail expect a 4-6 week wait (could be less if in stock in Japan)
If you select container service expect 4-6 month wait
All sales are final, please expect delays and do not purchase from this section if you're in a hurry!
If you have a question send us an email at [email protected]
Check out our "In Stock Aero" page for all aero we have in stock in the USA ready to ship
Original: $530.00
-65%$530.00
$185.50
Description
Spirit Rei | Fender Flares +50mm for Toyota Hiace 100 Series
The vehicle we developed is a 4WD, a must-have in snowy regions.
Lowering a 4WD vehicle is difficult due to the front differential and driveshaft, and since it's used for both work and leisure, we felt that a 2-inch lowering was the limit of what we could achieve through suspension.
To fill the large gap between the fender and tire, we began sculpting along the panel lines of the original fenders. While lowering the front by 55mm and the rear by 50mm, we achieved a fender arch that was as natural as possible, resulting in a simple-looking but carefully crafted fender.
The overfenders project approximately 15mm, allowing the wheel rim and tire to peek out for a racy look.
Material: FRP (Painting is required after purchase)
*We do not accept painting requests.
Finish: Black gel coat
. Installation is with double-sided tape.
Projection: Approximately 15mm
Arch Down: Front: 55mm, Rear: 50mm
PLEASE NOTE:
This is a Japan parts Service, some items are made to order (typically 4-8 weeks to make)
If you select air mail expect a 4-6 week wait (could be less if in stock in Japan)
If you select container service expect 4-6 month wait
All sales are final, please expect delays and do not purchase from this section if you're in a hurry!
If you have a question send us an email at [email protected]
Check out our "In Stock Aero" page for all aero we have in stock in the USA ready to ship
